9 Foot 184U w/ 18 Inch Sides (Electric Hoist) - Manufacturer specs and special orders below. This body is available in lengths of 8′ to 11′ in 1′ increments. Inside width from side to side is 84″ SIDES: One piece sides with no welded seams. 10 gauge A607 grade-50 high tensile steel with boxed top rail and fully welded boxed rear corner post. 6″ side board gussets with full length rub rails, and box-type sidebraces. RUB RAILS: Full length 45 degree deflector panels are an integral part of the sides. FLOOR: 10 gauge -two piece high tensile steel floor with 2″ floor to side radius. A607 grade-50 steel. FRONT WALL: 10 gauge high tensile A607 grade 50 steel. Full width integral inverted V-type horizontal bracing. TAILGATE: 3 Panel fully boxed 10 gauge high tensile A607 grade 50 steel with boxed horizontal reinforcements and sloping lower deflector. Tailgate is 6″ higher than side. TAILGATE HARDWARE: Heavy duty: Standard upper hardware is offset cast steel hinge. Lower hook is cast steel: engages tailgate pin from top. Banjo eye keeps tailgate chain in position you select. LIGHTS &REFLECTORS: FMVSS 108 lights are standard, recessed for protection, rubber mounted and shock proof. UNDERSTRUCTURE: Completely jig built with 3″ structural channel crossmembers on 12″ centers and 5″structural channel longitudinal. Crossmembers are gusseted and welded to longitudinals. POPULAR OPTIONS: 36″ cab shield, 8 gauge sides, 3/16″ one piece floor, fold down 13″ sides, 18″ sides, quick release upper hardware, other options available. *Please call for pricin Price subject to change without notice due to the rising cost of steel.